Series Dual

Domus LTE/4G e 2G
These multi-carrier dual-band repeaters are designed to provide coverage in 2, 3, and 4G LTE modes for data and voice traffic in standard and VoLTE modes. Available with a power of 17 dBm in DL and 13 dBm in UL and a Gain of 65 dB in DL and 60 dB in UL. They use the 4G LTE standard at 800 MHz and 2G at 900 MHz; on the latter frequency, where present, it is also able to repeat the 3G standard.

  • Network: 800/E900 MHz
  • Data in 4G LTE and voice in VoLTE mode/Data and voice in 2 and 3G modes;
  • Suitable for small environments;
  • Compatible with all EU mobile providers;
  • CE, RoHS, and Radio Equipment Directive 2014/53/EU (RED) certifications;
  • Control via WEB interface, ETH port for remote control.
800/E900 Mhz
60/65dB
17dBm
Installation
Intelligent
5Tacche®

Description

Made with Intelligent Radio System ® Technology, they can be assembled and be in an optimal condition easily. The Domus Dual 800/900E model, with its 2×17 dBm of power, ensures efficient coverage in the home or small environments, capable of serving surfaces of over 350-400 m2. The Domus Dual 800/900E series can be equipped with different types of internal and external antennas to allow better coverage in larger environments. Where present externally, it regenerates the 2, 3G and 4G LTE signals at 800 and 900 MHz from the operators Wind-3, TIM, Vodafone, and Iliad.

Specifications

<
 UplinkDownlink
Frequency Range832-862/880-915 MHZ791-821/925-960 MHZ
Bandwidth30/35 MHz
Maximum Gain60dB±3dB65dB±3dB
Manual Gain Control31dB / 1dB Step
Output Power  17dBm±2dB
Power Consumption≦ 20W
Power SupplyDC 9V/5A 
Dimensions21*17*5cm
Weight≦1,5Kg
ConnectorsN-female 
Operating Temperature -10℃~50℃

It works

Signal amplification systems work on two separate frequencies: down-link and up-link. Down-link is the signal we receive on our cell phone from operator cells at a specific frequency while Up-link is the signal we transmit from the cell phone to the infrastructure of the various networks. The repeater by means of the external (or donor) antenna connected with a coaxial cable, picks up the signals from the operators' BTSs and amplifies them; then the enhanced and hardened signals are sent to the internal service antenna or antennas connected to the repeater, again by means of a coaxial cable. At this point the signal is ready to be used by your cell phone.
The system will transfer and amplify the signal from Vs cell phone (Up-Link) to the operators' cells with a reverse path from the previous one.

Installation

Main steps:
The installation of a signal amplification system must always and exclusively be carried out by specialized companies with the appropriate equipment. “DO IT YOURSELF” in the absence of experience, competence, and the ability to carry out checks once the system is completed is a practice that should not be done under any circumstances. Inside the package, there is an installation manual in Italian with all the information necessary to carry out the correct assembly.

Accessories