Series Tri

Domus 800/E900/2100
These multi-carrier tri-band repeaters have two LTE bands at 800 and 2100 Mhz and a 2 and 3G UMTS at 900 Mhz for data and voice traffic in standard and VoLTE modes. They regenerate the signals present externally with a higher number of channels. Made with Intelligent Radio System ® Technology, they can be assembled and be In an optimal condition easily, its 3×17 dBm of power ensures efficient coverage, capable of serving surfaces of over 200 - 250 m2.

  • Network: 800/E 900/2100 MHz;
  • Data and voice in 2, 3, and 4G LTE VoLTE modes;
  • Suitable for small environments;
  • Compatible with all EU mobile providers;
  • CE, RoHS, and Radio Equipment Directive 2014/53/EU (RED) certifications;
  • Control via WEB interface, ETH port for remote control.
    • i>
800/E900/2100 Mhz
60/65dB
17dBm
Installation
Intelligent
5Tacche®

Descrition

Domus Triband 800/900E/2100
Can be accessorized with different types of internal and external antennas to allow better coverage in larger environments. It regenerates the 4G LTE VoLTE data and voice signals at 800 and 2100 Mhz of the operators Wind 3, Vodafone, and TIM, and where present the 3G standard at 2100 Mhz of the operators Wind-3 and Iliad. At 900 MHz it amplifies the 2 and 3G voice and data standard for Iliad, TIM, Vodafone, and Wind-3 operators.

Specifications

 UplinkDownlink
Frequency Range832-862/880-915/1920-1980 MHZ791-821/925-960/2110-2170 MHZ
Bandwidth30/35/60 MHz
Maximum Gain60dB±3dB65dB±3dB
Manual Gain Control31dB / 1dB Step
Output Power  17dBm±2dB
Power Consumption≦ 20W
Power SupplyDC 9V/4A 
Dimensions29*21*5cm
Weight≦2,3Kg
ConnectorsN-female 
Operating Temperature -10℃~50℃

It works

Signal amplification systems work on two separate frequencies: down-link and up-link. Down-link is the signal we receive on our cell phone from operator cells at a specific frequency while Up-link is the signal we transmit from the cell phone to the infrastructure of the various networks. The repeater by means of the external (or donor) antenna connected with a coaxial cable, picks up the signals from the operators' BTSs and amplifies them; then the enhanced and hardened signals are sent to the internal service antenna or antennas connected to the repeater, again by means of a coaxial cable. At this point the signal is ready to be used by your cell phone.
The system will transfer and amplify the signal from Vs cell phone (Up-Link) to the operators' cells with a reverse path from the previous one.

Installation

Main steps:
The installation of a signal amplification system must always and exclusively be carried out by specialized companies with the appropriate equipment. “DO IT YOURSELF” in the absence of experience, competence, and the ability to carry out checks once the system is completed is a practice that should not be done under any circumstances. Inside the package, there is an installation manual in Italian with all the information necessary to carry out the correct assembly.

Accessories